After full discussion, Aide Memoire of Hefei Urban Environment Improvement Project has finished.

经充分讨论，形成合肥市城市环境改善项目技援启团备忘录。

Do you want to proceed and install the CD booter?

你是否想继续，并安装CD启器？

OK dovecot ready.quitOK Logging outConnection closed by foreign host.

检查Dovecot服务器是否正常启 to character is .

The machine will start by itself in a few seconds.

几秒钟后, 机器将自行启。

Every time I got my motorcar started the engine cut out.

"每次我启我摩托车,发机就熄火了。"

Do you close out safari, open settings, traverse the menus and reenable the 3g?

你会不会关掉Safari，打开设置，扫遍菜单，重启3G呢？

This machine has lots of knobs on it. Which one starts it?

这机器有许多旋钮。是启它？

Starting the three-phase asynchronous motor is important in the teaching and experiment Electrotechnology.

三相异步电机启，是《电工学》教学和实验重点容。

I jumped his saloon from my car's battery.

我靠自己车上电池助推启了他轿车。

The Government wants to put the new reforms in motion before the election.

政府想在大选前启改革。

My printer’s gone haywire. It keeps stopping and starting.

我打印机乱套了，不停地中断又重启。

Then start the desander and desilter.

然后启除砂器和除泥器。

The paper describes the distinguishing features of developing small-scale for group stater panel in engine control room.

论述船用组合启盘小型化发展特点，分析了启盘组成部件改造和国外产品技术进展。

All of the genes necessary for the lytic cycle are expressed in polycistronic transcripts from three promoters.

编码噬菌体结构成分基因则排列为簇。裂解周期所需要基因则以三启子起以多顺反子转录形式表达。

On touchless devices keypad arrows are equal to the screen ones and joystick click is similar to start button.

在键盘上箭头等于屏幕和操纵杆点击无接触装置类似启按钮。

My car won’baby bluet start.

我车启不起来。

If something geos Very Wrong Way (tm), don't panic. Any way you still have unencrypted partition to boot from.

如果出了什麽错误，不要紧张。你始终可以从非加密分区启。

Beton activates a man-sized gin to catch his target. Four hemicyclic iron ring will jut from the ground and immobilize the target.

比顿启对人用捕兽夹抓住他目标。四半圆形铁环将从地面突出，使目标无法移。

Once the user enters the sensor's effective range and then steps away, the Flushometer Solenoid initiates the flushing cycle to flush the fixture.

旦使用者进入感应器感应有效范围后离开，冲水阀螺线管就启次冲水冲刷卫生洁具。

The system uses PLC procedure control, start-up, forward or backward soldering gun, arc starting, workpiece circumgyration, etc full welding process all can complete automatically.

系统采用PLC程序控制，启、进退枪、引弧、工件旋转等焊接全过程均能自完成。