A modified form of sprue gate is also used on underfeed moulds and runnerless moulds.
在点浇口形式的模流道模也用到另一种形式主流道。
In this paper, the arrangement of cavities, the dimension calculation of sprues and gates and the method of mold-testing for a special hooks multi-cavitis plastic injection mold are introduced.
本文塑料扣码为例介绍了多腔注射模浇注系统型腔的排布、非平衡排布时欲达到同时充满型腔浇口尺寸的算及调试。
声明：以上例句、词性分类均由互联网资源自动生成，部分未经过人工审核，其表达内容亦不代表本软件的观点；若发现问题，欢迎向我们指正。
This mold has 3 drops with 4 gates .
套模具有3个点位4个浇口。
The gate insert needs better cooling .
浇口镶件需要更好冷却。
The final gate position depends on the moldflow analysis .
浇口位置取决于模流分析。
Which gate type does the customer want to adopt ?
客户想采用哪种类型浇口？
Good gate cooling can freeze the gate faster .
好浇口冷却可以更快地冻结浇口。
The insufficient gate cooling can lead to vestige .
浇口冷却不足导致浇口过高。
Filament is because the gate is not totally frozen .
拉丝是因为浇口没有完全凝固。
2 valve pin gates transfer to 4 cashew gates .
2个阀针浇口转4个牛角浇口。
I think we can move the location of the gate from here to there .
我觉得我们可以把浇口位置从动到那。
The customer asked us if we could move the position of the gate .
客户问我们能否动浇口位置。
We should use the point gate instead of the side gate .
我们应该使用点浇口而不是侧浇口。
This kind of gate can realize degate .
种浇口可以实现浇口脱落。
It will be easier for the gate layout if we rotate the product by 90 degrees
如果我们把产品旋转90度，对于浇口排布更容易。
This gate should be closed during the first shot .
在第一次射出时，应该关闭个浇口。
These two gates are too close to each other .
两个浇口太靠近了。
The second gate will open after the first gate is closed .
第一个浇口关闭后，第二个浇口将打开。
The insufficient gate cooling will cause vestige.
浇口冷却不足造成浇口残留。
The gate insert is wearable and needs 2 spare pieces.
浇口镶件容易磨损，需要备两个备件。
Prior to tool build, gating and ejector locations need to be approved by the product engineer.
开模前，浇口位置和顶出位置需要得到产品工程师同意。
Is it my mistake not to use the cashew gate ?
没有使用牛角浇口，是我错吗？
关注我们的微信
下载手机客户端
划词翻译
详细解释
流道模
也用到另一种形式主流道。
塑料扣码为例介绍了多腔注射模浇注系统
套模具有3个点位4个
冷却。
导致
动到那
