The camshaft rotates in phase with the crankshaft, but at half its speed.

凸轮轴和曲轴协调旋转, 但速度仅是曲轴。

These include dobbies, cam motions, electronic Jacquard machines and Jacquard harnesses.

产品包括凸轮开口装置、电子多臂机、电子提花机和提花织造用通丝。

The main products are as follows, exhaust manifold, bent axle, camshaft, rubbing sassafras nestification, gearbox, support, flywheel, etc.

排气歧管、曲轴、凸轮轴、摩擦嵌套、变速箱、支架、飞轮等。

Die should contain a minimum of one idle station to accommodate future design considerations. i.e. restrike cam pierce etc.

摸具应至少包含个空站以适应未来设计变更，回整，凸轮，冲孔等。

ACD (Active Camming Device) - Protection device that secures in rock cracks or pockets by means of spring-loaded cams. See SLCD.

使用弹簧凸轮装置在岩石裂缝或者岩洞做确保保护器材。

Furthermore, the models for the analyses, such as pressure angle, curvature, kinetostatics, and input torque, of the mechanism are built.

且建立该凸轮机构之各项特性分数学模式，包括压力角分、曲率分、静力分，及推导系统输入扭矩表示式。

SLCD (Spring-loaded camming device) -A piece of active climbing protection composed of a number of cams on a stem with a trigger bar.

种主保护器材，由绳缆串联定数量凸轮组成，绳缆有引棒控制。

In case that the camshaft signal measured by the first falling edge after dentation is low, then the following TDC would be of the first cylinder.

若缺齿后第个下降沿检测到凸轮信号为低，则接下来TDC是缸TDC。

In this paper,the cam explorator in contour lathe is designed direct according to the contour of primary products with the mathematical analogue of the working course of the cam。

通过对凸轮加工过程数学模拟，利用原始产品凸轮外形来直接设计凸轮仿形车床靠模。