The class and function of C subfunction for graphic dimensions mark are elaborated.

阐述了图形尺寸标C语言子函数的分类及功能。

Preshrunk process should be carried out for dimensional stability, so ideal dyeing results are available.

为防止水洗尺寸变化进行理,从而获得了理想的染色效果。

Bark opaquely brown, gray spotted, spots unequal in size.

树皮不透光的棕色，灰色点，在尺寸方面不等长。

She metered it and found it to be the exact size.

她用仪器测量了一下, 发现正好是个尺寸。

The response of T1 phase size to heattreatment processing and rare-earth element content are discussed.

根据T1相尺寸测定结果，分析了T1相尺寸与热理工艺、稀土元素之间的关。

The cost is not sensitive to the batch size.

价格不因整批尺寸的变化而发生波动。

Petals 5, differing slightly in size, imbricate, sometimes unguiculate, free, keel without apical appendages.

花瓣5，在尺寸方面的不同稍，覆瓦状，有时具爪，离生，没有顶端附属物的脊。

The tailor took my measure for a new suit.

裁缝量了我的尺寸准备为我做套新衣服。

The calculations agree well with experimental results, which indicates that the model is instructive on the optimization of the dimension of inertance tube in Stirling type pulse tube cooler. 3.

表明该方法对斯特林型脉管制冷机中惯性管尺寸的选取具有重要指导意义。

This control effect can be got by designing the size of pokedwheel,using the self locking character of worm wheel and worm pole and connecting the pawl mechanism with overtravel ...

通过有效设计拨轮的尺寸，利用蜗轮蜗杆的自锁特性，将棘轮机构与行程开关联为一体，达到自动输球控制的目的。

Recently a few months, they already announced the advanced science and technology of a series of contractible chip dimension, the again and again challenges the physical law of this microcosmos.

在比来几个月，他们已公布了一列小芯片尺寸的前进前辈科技，一次又一次挑战个微观世界的物理定律。

In this paper, the arrangement of cavities, the dimension calculation of sprues and gates and the method of mold-testing for a special hooks multi-cavitis plastic injection mold are introduced.

本文以塑料扣码为例介绍了多腔射模统设计中型腔的排布、非平衡排布时欲达到同时充满型腔口尺寸的计算及调试。

Through the motive analysis ,the article states the affect to the chip size and geometric figure from the changes of cutting angles in the chipping course of durm chipper.

通过运动分析论述了鼓式削片机削片过程中遇角的变化对木片尺寸和几何形状的影响。

The drawing method for the double channel impeller is studied.It is found that there is an in-conformity between the dimensions of plane-view and pinacoid-view of fluid cross-section.

摘要研究了双流道污水泵叶轮常用的图纸表达方法，发现平面图上的断面投影结果与轴面图中确定的断面形状尺寸不一致的问题。

The PP armchair produced by this special compound has a good impact resistance, high strength, good ageing resistance, good corrosion resistance and dimensional stability and good lighteness.

用该专用料生产的方椅具有强度高、韧性好、耐老化、耐腐蚀、尺寸稳定、表面光亮等优点,现已批量生产。

With greater axial and radial load rating capacity, good replaceability of components. The shaft can be adjusted through external hexogan then to adjust the axial part dimension.

轴承径向和轴向的承载能力都比较大，各配件可替换性强。轴承通过调节偏心外六角来调整芯轴位置进而达到调整侧滚轮轴向尺寸的目的。

The mechanical status of nutted rod in drawing pipe with short mandrel rod is analyzed, the analysis basis for the dimensions design of nutted rod offered.

文章分析了短芯棒拉拔管材时拉杆的受力，并对拉杆的尺寸设计提供了分析的依据。

Serigraphy and heat transfer production process, a machine to do this is with strips of a barrel roll was well cut into the desired size.

平版冷转印不入产工艺，一是用裁膜机不兵冷转印纸卷裁不败所需尺寸。

In the spring Utricularia warburgii produces 5-20 cm. flower scapes bearing 2-6 violet-blue flowers, 8mm in size and bearing a yellow splotch at the throat.

春季时瓦堡狸藻可延长5到20公分。花茎结出2到6朵紫萝兰色或蓝色的花朵，尺寸为8毫米，而且在花冠喉部上带有黄色的斑点。

Ordinarily, the thickness of velocity boundary layer and grid Reynolds number are used as the delimitating standards for flow field and aerothermal heating computations respectively.

通常的做法是，对于流场计算以速度边界层厚度作为法向网格尺寸划分标准，对于热流计算则根据网格雷诺数确定网格尺寸。