Quickly he located the trouble in the engine and set it right.

他很快找出并排除了发动机的故障。

The branch system of safeguard, the design of alarm, interlock and shutdown, can ensure the safety of plant and its circumambience and reduce the lost of fault.

为保证企业生产过程及周围社区的安全,设计了过程安全保障系统,现装置的报警、联锁和紧急停车,把因故障造成的损失降低至最小。

In order to further discuss the identification of fault after the detection, a nonlinear online neural network approximator is used to provide an estimate of the fault.

为了进一步现故障特性的辨识与跟踪,讨论了一种利用神经网络非线性故障模式进行在线逼近的鲁棒故障诊断方法。

By means of ballistic pulsimeter operation of recent years, the relative wealth of experimence is accumulated. The better effect in bearing failure detection is obtained simultaneously.

经冲击脉冲计的使用，积累了较丰富的经验，同时在轴承的故障诊断中取得了较好的效果。

Based on this, the veracity of the rotor fault diagnosis can be improved through the distance of the information entropy curve chart at the multispeed.

例计算表明，信息熵距能够较好的区分故障类别，在此基础上，通过转速下的熵距曲线提高转子故障诊断的准确性。

With the lucubrate research of fault mechanism, according to the domino theory and ICAO, to bring forward the idea of electric power system fault chain.

在深入研究电力系统连锁故障机理的基础上,依据骨牌论和国际民航组织(ICAO)防止事故手册上提出的“事故链”概念,提出了“电力系统事故链”的思想。

Some common troubles such as poor throwing power,burnt deposit on rim,dull gray coating,piebaldism,blue film,hazy deposit,spongy surface and roughness in decorative chromium plating were summarized.

介绍了装饰性镀铬最常见的质量故障:均镀能力差、边角易烧焦、铬层暗灰色、花斑、蓝膜、雾状、麻面和粗糙等。

The diagnosis principle and diagnosability conditions are proposed, and the normal tolerance network test nede voltage interval are given by interval iterative algorithm.

该方法给出了容差情况下诊断的原理和诊断性条件，并利用区间迭代算法，给出了容差网络无故障情况下的测试节点电压范围。

Use high speed oscillation cobbra , ensure all parts of products have same strength during oscillation ,prolong tester lifespan, decline failure rate.

采用高速振动头同步振动，保证在振动时各部位的产品受到的力的情况一致，并延长试验机的寿命及故障率的降低。

The interclass difference matrix is calculated by using the fault class feature data from simulation in order to determinate the ambiguity sets.

算法利用电路仿真故障特征数据计算故障的类间差异矩阵，从而完成故障类模糊集的确定。

The method to check short-circuit point between parallel conductors in transformer winding by Gaussmeter and to repair fault point are introduced.

摘要介绍了运用高斯计来探查变压器绕组内并联导线间短路点，并故障点进行修复的方法。

The fault diagnosis problem of active network is studied in this paper with the emphasis upon its solvability and diagnosability.

摘要本文研究有源网络的故障诊断问题，著重研究其解性与诊断性。

The briefing covers quality of the shell pierced by the three-high piercing mill, thespecific rolling failures and countermeasures thereagainst.

简要地介绍了三辊穿孔机所穿毛管的质量及该穿孔机特有的轧制故障和预防措施。

ELCB or GFCI device with trip load of no more than 30 milliamp will be fitted and fully operational.

有故障的设备不使用，要报告给监护人员准备维修或者取走不用。

The plane had a breakdown in the air, but it was fortunately removed by the ace pilot.

飞机在空中发生了故障，但幸运的是被王牌驾驶员排除了。

Result Causes of dysfunction of PICC included staxis around stoma(38.4%),catheter blockage(26.0%),catheter displacement(13.7%),catheter defluxion(9.6%),extubation(8.2%) and local infection(4.1%).

结果发生故障的主要原因有:穿刺口渗血(38.4%)、导管阻塞(26.0%)、导管移位(13.7%)、导管脱落(9.6%)、拨管(8.2%)和局部感染(4.1%)。