A modified form of sprue gate is also used on underfeed moulds and runnerless moulds.
在点浇口形式的模具或无流道模具中也用种形式主流道。
In this paper, the arrangement of cavities, the dimension calculation of sprues and gates and the method of mold-testing for a special hooks multi-cavitis plastic injection mold are introduced.
本文塑料扣码为例介绍注射模浇注系统设计中型的排布、非平衡排布时欲达同时充满型浇口尺寸的计算及调试。
声明：以上例句、词性分类均由互联网资源自动生成，部分未经过人工审核，其表达内容亦不代表本软件的观点；若发现问题，欢迎向我们指正。
This mold has 3 drops with 4 gates .
这套模具有3个点位4个。
The gate insert needs better cooling .
镶件需要更好的冷却。
The final gate position depends on the moldflow analysis .
最终的位置取决于模流分析。
Which gate type does the customer want to adopt ?
客户哪种类型的？
Good gate cooling can freeze the gate faster .
好的冷却可以更快地冻结。
The insufficient gate cooling can lead to vestige .
冷却不足导致过高。
Filament is because the gate is not totally frozen .
拉丝是因为没有完全凝固。
2 valve pin gates transfer to 4 cashew gates .
2个阀针转4个牛角。
I think we can move the location of the gate from here to there .
觉得们可以把的位置从这里移动到那里。
The customer asked us if we could move the position of the gate .
客户问们能否移动的位置。
We should use the point gate instead of the side gate .
们应该使点而不是侧。
This kind of gate can realize degate .
这种可以实现脱落。
It will be easier for the gate layout if we rotate the product by 90 degrees
如果们把产品旋转90度，对于的排布更容易。
This gate should be closed during the first shot .
在第一次射出时，应该关闭这个。
These two gates are too close to each other .
这两个太靠近了。
The second gate will open after the first gate is closed .
第一个关闭后，第二个将打开。
The insufficient gate cooling will cause vestige.
冷却不足造成残留。
The gate insert is wearable and needs 2 spare pieces.
镶件容易磨损，需要备两个备件。
Prior to tool build, gating and ejector locations need to be approved by the product engineer.
开模前，位置和顶出位置需要得到产品工程师的同意。
Is it my mistake not to use the cashew gate ?
没有使牛角，是的错吗？
关注我们的微信
下载手机客户端
划词翻译
详细解释
种形式主流道。
塑料扣码为例介绍
注射模浇注系统设计中型
哪种类型的
导致
觉得
