1.The process treating roast dust from zinc pyrometallurgy is,in general,the second roasting by rotary kiln.

1.处理火法炼锌高温态化焙烧过所产的烟尘,用回转窑二次焙烧。

2.The arsenolite cinders were treated by the processes of oxidizing roasting-pyrolusite pulp absorption,magnetizing roasting-magnetic separation and acid leaching.

2.用氧化焙烧—软锰矿浆吸收、磁化焙烧—磁选、酸浸工艺处理砷华废渣。

3.It is proved that preduction of high-carbon graphite by chloridizing roast is better than by alcali.

3.指出氯化焙烧法生产高碳石墨较碱法为优。

4.Composite W-Cu oxide nanopowder was prepared by spray-drying and milling of ammonium metatungstate(AMT) and cupric nitrate.

4.用偏钨酸铵、硝酸铜通过喷雾干燥、焙烧、球工艺制备纳米氧化钨铜复合粉末。

5.Top, the calcinator in the sodium tripolyphosphate plant; above, the atomic absorption spectrophotometer, being used in the laboratory.

5.（上）焙烧机一角。（下）检验室中的原子吸收光谱机。

6.During heating,phase transformation and expansibility of the new quartz sands and the calcined Quartz sands from two places were determined by DSC and thermodilatometry.

6.本研究用DSC热膨胀仪对两种石英砂的原砂焙烧砂在加热过中的热膨胀进行了分析。

7.The thermoanalysis results of the catalysts show that interactions between the precursors of nickel and carrier change with the nickel loading during the calcination treatment.

7.热分析表明，焙烧过中不同镍负载量的催化剂镍前体与载体前体之间发生的互作用不同。

8.Aimed at utilization of iron resources in pyritic slag,the study on production of metallized agglomerate with pyritic slag through coal based DR process was conducted.

8.为合理利用硫酸烧渣中的铁资源，进行了煤基直接还原生产金属化团块的研究，提出了润造球-预热焙烧-磁选-冷固结成型的新工艺。

9.The feasibility of roasting reduction method to dezinc the Zn bearing BF dust was proved by energy spectrum analysis and differential thermal(DT) and thermo gravimetric(TG) analysis firstly.

9.通过能谱、差热及热重分析等验证了用还原焙烧的方法脱除高炉含锌粉尘中锌的可行性。

10.The IR spectra of hydrogel, alcogel and aerogel of BaFe12O19 were studied, and the ones of the powders calcined at different temperatures for different time were also studied.

10.对钡铁氧体的水凝胶、醇凝胶以及气凝胶的红外光谱进行了初步的观察，同时对不同焙烧温度及时间所得粉末的红外吸收光谱进行了考察。

11.In addition, this paper studied the influence factor, namely, the mass of TiO2, mass of SnO2, the torrefy temperature and time of the reflect-material, on the capability of the reflect-material.

11.对TiO2用量、SnO2用量、反射材料焙烧温度时间等影响因素进行了研究。